.Operating instructions.Please ensure both yourself and any helpers read these operating instructions carefully and in full before using your bath lift. These operating instructions should be retained for future reference. This bath lift is designed and manufactured to assist individuals in getting in and out of the bath/tub.Only continue if the light on the hand control is constant or flashing green and if the battery has been charged within the last 7-10 days. When the seat reaches the top of the bath/tub:. Release your finger from the UP button;.Operating instructions Contents Unpacking the bath lift Warranties, maintenance & servicing 1. Unpacking the bath lift.
Maintenance and servicing.11.Diagrams for operation and explanation of use are on the fold-out diagram sheet attached to the rear of this booklet 1. Unpacking the bath lift Open the packaging and ensure the bath lift is not damaged and that all parts are included. If it has been damaged in transit or parts are missing, contact your supplier immediately. Ensure that no metal objects touch the contacts on the battery, as this will damage the battery. Use only the Mountway charger supplied to charge the battery and for no other purpose. Preparing the bath/tub for installation i) Remove any non-slip mats from the bath/tub.4. Installing the bath lift i) Pick up the bath lift holding it as close as possible to your body.
Ii) Place the suction feet on the flat bottom of the bath/tub and as far back as possible at the opposite end to the taps/faucets. If in any doubt, recharge the battery before use (see section 2, “Charging the battery”). NOTE: The battery is for use solely with Mountway bath lifts and cannot be used to operate any other product. Using the bath lift NOTE: Ensure all four suction feet are attached to the bath/tub surface before each use.v) Before lowering the bath lift, extend your feet out in front of you and keep hands above the seat to avoid any risk of entrapment. Vi) To lower yourself to the bottom of the bath/tub, press the DOWN button on the hand control (see fig 7).7.
When the bath lift is not in use i) If you wish to clean the bath lift whilst it is in the bath/tub (see section 9, “Cleaning”), we recommend doing so when it is at its highest position in the bath/tub. This allows access for cleaning both the bath/tub and the underside of the bath lift.Repairs and servicing must be entrusted to a Mountway authorised dealer or engineer. The bath lift should be inspected annually by a Mountway authorised dealer or engineer, who will check that there are no loose fittings or any other evidence of mechanical damage.11. Warranty This product is sold with the benefit that, in the event of any defect of manufacture or material appearing within 1 year of the date of receipt of the product, the defect will be rectified free of charge, provided that: i) Reasonable evidence is provided (e.g.Symbol Explanation Maximum load - lifting capacity (person).
Surface hot to touch. Technical data The bath lift seat and base is made of glass-filled polypropylene.
The base frame tubes are made of aluminium. The hand control and battery are made of ABS. The hand control button cover and suction feet are made of thermoplastic elastomer.Bath Lift Lifting capacity (person) 127kg/20 stone/280lbs Net weight (excluding battery) 6.5kg/14.33lbs Seat height UP 460mm/18.11in Seat height DOWN (loaded) 70mm/2.76in Power input 14.4V dc nominal 7A max Duty cycle Not more than one bath per 15 minutes Degree of protection IP66 Hand Control (Battery) Input.14. Troubleshooting Symptom Possible Cause Solution Section Bath lift does not. Battery is flat. Charge battery. Section 2 move.
No sound. Insert battery correctly into both tracks. Battery is not Section 5 from the motor. On hand control cradle and slide all the connected to hand control.Symptom Possible Cause Solution Section Bath lift.
Battery is not fully. Charge battery. Section 2 only moves charged.
Excessive user load. Do not use bath lift if you weigh over Section 13 20st/127kg/280lbs. Lower bath lift, pull flaps free from Section.Symptom Possible Cause Solution Section No lights appear. Insert battery correctly into both tracks. Battery is not Section 5 on hand control connected correctly on hand control and slide all the way to when buttons are to hand control. The end until it clicks.15. Accessories The bath lift can be supplied with a range of optional accessories: Accessory Part No.
Soft cover set (back and seat) BB3103 Provides even greater comfort. Accessory Part No.
See All 24 Rows On Www.showerdoc.com
Side flap protector AB283 Side flap protectors are available should your bath lift not sit far back enough in the bath/tub to avoid integral handles.Accessory Part No. Side flap protector extension kit AB287 (non- hooking) Comprises 1 non-hooking side flap protector and 2 clips.
Neptune Solo Shower Manual Download
Beautiful shower screens for beautiful bathroomsPivotech shower screens set the standard for style, quality, and value.Home and bathroom design is fashion design. Our team develops new products to stay ahead of trends in home design and ensure Pivotech showers offer fashion and function. Manufactured from the highest quality materials, Pivotech systems deliver an investment in quality.Pivotech shower enclosures are designed to be versatile and accommodate the layout of different rooms. Our manufacturing process ensures Pivotech shower screens look amazing and work perfectly.